FujiFilm Finepix S3000, Service Manual

Page: 68 / 82

68
FinePix S3000 Service Manual
5.Inspection
Battery down
(backup)
Playback
1)Connect the power cable jig with
the camera.
2)Set the power-supply voltage.
3)Set the mode dial to the AUTO mode.
Turn on the power switch (POWER_ON).
4)Flash unit pop-up->Push down.
(backup confirmation)
5)Set the Priend voltage.
6)Set the end voltage.
5.0 +-0.3V
11
4.20+-0.02V (battery warning displayed.)
3.50+-0.02V (Lens retracts and main power swiched OFF.)
12 Current
consumption
Auto
photography
LCD-ON
1)Connect the power cable jig with the camera.
2)Set the power-supply voltage.
3)Set the mode dial in auto mode.
Turn on the power switch.
(POWER_ON) > (LCD_ON)
4)Current consumption confirmation .
5.0+-0.05V
450mA or less
13 Video signal
1)video cable is connected with video
Jack of the camera.
2)Play Back the Flash photographic
image.
3)Play Back the macro resolution
photographic image.
4)Remove the video cable from the
camera.
2) Y-Level 50+10IRE(NTSC) / 350+-70mV(PAL)
H-resolution:Center350TV/Line:Around300tv/line(NTSC)
H-resolution:Center300TV/Line:Around250tv/line(PAL)
14 Standby current
1)Connect the power cable jig with the camera.
2)Set the power-supply voltage.
3)Confirm the current at camera power off.
4.5 +-0.1V
1mA or less
15
1)Power SW
2)Initial return factory setting.
Each model's setting is [5-4. Factory
setting] is confirmed.
3)Slot cover
4)Battery lid
5)Flash unit
6)Lens Shizdou and the barrier must shut.
7)Thing with which surface of LCD is not dirty.
8)Clean externals of the camera.
OFF mode
Close
Close
Close
[Setting and clearing data.]
1)Connect the USB cable with PC that has installed the
treatment device driver.
2)Connect the USB cable with the camera.
3)Turn on the power switch while pushing the shutter
button with the battery cover opened.
(POWER_ON)
4)Turn off the power switch.
(POWER_OFF)
5)Confirm the date setting was cleared.
*The operation of the PC side is unnecessary.
Power cable jig
regureted power supply
Ammeter
Ammeter
Preparations for adjustment
(measurement point, subject, other)
Sequence Check item Mode
Method of adjustment
(VRs, waveforms, required, values)
Measuning
equipment and jigs
Measurement point
(VRs, position)
Factory setting
MODEL US/CA EU/EG/GE/AS CH
FLASH AUTO
LCD-BRIGHTNESS Center
QUALITY 1M(Still) / 320x240(Movie)
SHOOTING MODE AUTO
SELF-TIMER OFF
DATE/TIME YYYY.MM.DD
Setup screen
Page 1/2
Page 2/2
5-4.Factory setting
Playback
OFF