Fuji Bikes ROBIN RGX6500, Service Manual

Page: 43 / 48

43
8-4 NO DC OUTPUT
8-4-1 CHECK THE AC OUTPUT.
Check the generator by following Step 8-1-1 through Step 8-1-2.
8-4-2 CHECK THE DC BREAKER.
If the DC breaker turned off while charging a
battery, check the cables for short-circuit or
connection in reverse polarity before resetting
it.
NOTE: If the DC output is used to charge
a large capacity battery or an over
discharged battery, an excessive
current may flow causing.
8-4-3 CHECK THE WIRING.
Check all the wires to be connected correctly.
8-4-4 CHECK THE DIODE STACK.
Remove the end cover and check the diode
stack with a circuit tester.
Refer to Section 6-7
“
DIODE STACK
”
for the
checking procedure.
8-4-5 CHECK THE DC COIL
Check the resistance between two Brown leads from stator with a circuit tester.
If the resistance reading is much larger or smaller than the specified value, the DC coil of the
stator is faulty. Replace stator.
9. WIRING DIAGRAM
RGX6500, 7500