Fuji Bikes ROBIN RGX6500, Service Manual

Page: 20 / 48

20
section, replace with a new one.
6-8 OIL SENSORS
(1) Disconnect wires coming from the sensor at the connection.
(2) Loosen the sensor to remove it from the engine.
(3) Plug the opening of oil filler hole (created after sensor is removed) with suitable means such
as oil gauge.
(4) Connect the removed wires again with the oil sensor.
(5) Start the engine with the oil sensor removed and confirm if ;
a. Engine stops after 5 seconds which is normal, or
b. Engine does not stop after more than 10 seconds which is unusual.
NOTE: The sensor will not operate properly when wire is broken or poorly connected.
Check the wires for correct connection. If it fails to stop within 5 seconds after the wirings
have been checked, the sensor is defective. Replace the sensor with new one.
6-8-1 SPECIFICATIONS
6-8-2 CONSTRUCTION AND OPERATION
Disconnect wires coming from the sensor. The
oil sensor is composed of the float, permanent
magnet incorporated into the float and the oil
sensor.
In accordance with the oil level, the float moves
up and down.
When the oil level is high, the float
moves up.
When the oil level is low, the float
moves down.
The permanent magnet is close to the lead
switch, and the lead switch is activated by the
magnetic force.
NOTE: With regards to the wiring diagram,
please refer to the section 9 (page46).