
WWW.FUHR.DE
14
834
autotronic
881
multitronic
4x
1. Swipe one of the master-fi ngers
four times
over the line-scan-
ner. Once the master fi nger has
been recognised, the red and
green LED‘s will light up and
fl ash in sequence.
2. If the delete process has been
successfully completed, both
LED’s light up permanently.
If one waits for
more than
10 seconds
between the single
steps, the reset procedure is
aborted!
7.3 Resetting the radio fi ngerprint scanner with a master-fi nger:
Delete all fi ngers
If one of the master-fi ngers is swiped four times consecutively over the line-scanner, all fi ngers (incl. master-
fi ngers) are deleted from both channels.
No
new serial numbers/telegrams for radio communication are
generated, i.e. the radio fi ngerprint scanner does not have to be tuned in again to the receiver used previously.
When in the reset-/ex-works condition, the red and green LED’s light up permanently. Please proceed as follows:
Please be sure to note that in this restored status everybody is capable of tuning in new
master- and user-fi ngers and to transmit an opening-authorised radio signal to the
previously tuned in recipient control of the motor lock or the universal radio adapter. That
is to say that you should tune in the master-fi ngers immediately after the installation and
the electrical connection of the radio fi ngerprint scanner. If this is not possible, use the reset
button’s delete function (page 13, chapter 7.2).
1x
2x
3x
4x