Frymaster Universal Holding Cabinet, Service Manual, Page: 21 / 55

10-1
10 Product Selection For Each Slot
10.1 Program Mode
The following is the correct locations to program the slot controls based on the configuration of trays
and products:
•
1/3-size plastic tray – Since each slot can accommodate 3 trays, all displays can be programmed
for a product. Remember, the temperature parameters established by the left display product will
be in effect for the entire slot, but the timing and product settings can be different for each
display within a slot.
•
1/2-size plastic tray with wire insert – Since each slot can only accommodate two trays, the left
and right displays will be used for controlling/monitoring the products. The center display
should be voided by selecting NONE; the left and right displays should be active with selected
product. Again, the temperature parameters established by the left display product will be in
effect for the right display but the timing and product settings can be different for each display
within a slot.
•
Full-size plastic tray – Since each slot can accommodate one tray, the center display will be
used to establish product parameters. The center display establishes the product parameter for the
slot. The left and right displays should be voided by choosing NONE with only the center
display active with the selected product.
Program Mode is used to select the products for each slot location. All selections are accomplished
through simple PAGE and MENU selections. Each slot position has a page of configuration menus.
The top slot in the cabinet is Slot 1. The
PAGE key is used to select slots 1 – 4. The MENU key
selects the configuration menu items (meal and tray location). The Up/Down arrow keys are used to
select the available product selections for each meal. To enter the program mode, press and hold the
MENU key for at least 5 seconds. The display will indicate the
PROG MODE
message.
To Enter Program Mode
ENTER
PAGE
MENU
SAUS SAUS SAUS SAUS
SAUS SAUS SAUS SAUS SAUS SAUS SAUS SAUS
Press and hold the MENU key for at least 5
seconds to enter Program mode
ENTER
PAGE
MENU
PROG PROG PROG PROG
MODE MODE MODE MODE