3–4
3.3.1 Adding Oil to the Fryer
3.3.1.1 Install the JIB (Jug In Box) Oil
Reservoir (JIB units only)
Remove the original lid from the oil
container and foil liner. Replace with the
provided cap, which has connected suction
hardware. Ensure the feeder tube from the
cap reaches to the bottom of the oil
container.
Place the oil container inside the cabinet
and slide it into place (as shown on the
following page).
Saddle Reservoir:
Has
plumbing attached to draw
oil from the reservoir to the
fryer vats.
ATO Reset Switch:
Resets the ATO
system after oil
change.
Figure 2
Avoid catching the suction hardware on the cabinet interior as the container is placed in the fryer. Press
and hold the orange reset button for 5 seconds (see Figure 7 on the following page).
3.3.1.2 Adding Oil to the Oil Saddle Reservoir (Saddle Oil Reservoir only)
Remove the Oil Saddle Reservoir lid (see Figure 3) and fill with oil. Once the
reservoir is full ensure the lid is placed over the reservoir. Ensure the quick
disconnect fitting with hose is fully seated to the fitting on the bottom of the oil
saddle.
The system is now ready for operation. As the fryer heats to preprogrammed
temperatures, the system will energize and then slowly add oil to the frypot as
needed, until the oil reaches an optimal level.
3.3.2 Routine Oil Changes
When the oil reservoir level is low and
displays TOP OFF OIL EMPTY, (see Figure 4).
Press the check button to clear the screen.
Once the reservoir is refilled and/or
replaced, press and hold the orange reset
button next to the oil reservoir (see Figure 9
on the following page) until the message in
the lower corner is no longer displayed. If
using solid shortening, see Appendix B for
instructions. If using a saddle oil reservoir
see section 3.3.2.2.
Figure 3
Figure 4
Top Off Oil Empty indicates that the oil reservoir is
empty.
