2-4
2.3
Positioning the Fryer
DANGER
No structural material on the fryer should be altered or removed to accommodate placement of
the fryer under a hood. Questions? Call the Frymaster Dean Service Hotline at 1-800-551-8633.
1.
Once the fryer has been positioned at the frying station, use a carpenter’s level placed across the top
of the frypot to verify that the unit is level, both side-to-side and front-to-back.
To level fryers, adjust the casters being careful to ensure the fryer(s) are at the proper height in the
frying station.
When the fryer is leveled in its final position, install the restraints provided by the KES to limit its
movement so that it does not depend on or transmit stress to the electrical conduit or connection.
Install the restraints in accordance with the provided instructions. If the restraints are disconnected
for service or other reasons, they must be reconnected before the fryer is used.
DANGER
Adequate means must be provided to limit the movement of this appliance without depending
on or transmitting stress to the electrical conduit. A restraint kit is provided with the fryer. If
the restraint kit is missing contact your local KES.
DANGER
Hot oil can cause severe burns. Avoid contact. Under all circumstances, oil must be removed
from the fryer before attempting to move it to avoid oil spills, falls and severe burns. This fryer
may tip and cause personal injury if not secured in a stationary position.
2.
Close fryer drain-valve(s).
3.
Clean and fill frypot(s) to the bottom oil level line with cooking oil. (See
Equipment Setup and
Shutdown Procedures
in Chapter 3.)
2.4
Installing the JIB Cradle (Applicable to fryer batteries of 2 or more only)
Open the fryer door (typically the far-right door)
and remove the cross brace used for shipping
support by removing the four screws (see Figure 1).
Install the JIB cradle shipped in the accessories pack
with the screws that were removed in the cross-
brace removal step (see Figure 2). If using the solid
shortening option, see Appendix A in the rear of
this manual for installation instructions. Install the
optional JIB splash shield to protect the bottom of
the JIB (see Figure 3).
Figure 1 Figure 2
Figure 3
