Frymaster FilterQuick Series, Technical Reference Manual

Page: 74 / 170

Automatic Filtering Fryers
4-30
CODE ERROR MESSAGE EXPLANATION
E01
M3000 ONLY
REMOVE DISCARD (Right)
A product cook is started on the right side of a split vat or in
a full vat that has a different setpoint other than the current
vat temperature.
E02
M3000 ONLY
REMOVE DISCARD (Left)
A product cook is started on the right side of a split vat or in
a full vat that has a different setpoint other than the current
vat temperature.
E03 ERROR TEMP PROBE FAILURE TEMP Probe reading out of range.
E04 HI 2 BAD High limit reading is out of range.
E05 HOT HI 1
High limit temperature is more than 410°F (210°C), or in
CE countries, 395°F (202°C).
E06 HEATING FAILURE
A component has failed in the high limit circuit such as
controller, interface board, contactor or open-high limit.
E07 ERROR MIB SOFTWARE Internal MIB software error.
E08 ERROR ATO BOARD MIB detects ATO board connection lost; ATO board failure.
E09 ERROR PUMP NOT FILLING
Oil not returning to vat quickly. Possible problems: dirty
pad, bad or missing O-rings, tripped or defective fi lter
pump, actuators or linkage.
E10 ERROR DRAIN VALVE NOT OPEN Drain valve failed to open; valve’s position is unknown.
E11 ERROR DRAIN VALVE NOT CLOSED Drain valve failed to close; valve’s position is unknown.
E12 ERROR RETURN VALVE NOT OPEN Return valve failed to open; valve’s position is unknown.
E13 ERROR RETURN VALVE NOT CLOSED Return valve failed to close; valve’s position is unknown.
E14 ERROR AIF BOARD MIB detects AIF missing; AIF board failure.
E15 ERROR MIB BOARD
Cooking controller detects MIB connections lost; check
software version on each controller. If versions are missing,
check CAN connections between each controller; MIB
board failure.
E16 ERROR AIF PROBE AIF RTD reading out of range.
E17 ERROR ATO PROBE ATO RTD reading out of range.
E18 Not Used
E19 CAN TX FULL© Connection between controllers lost.
E20 INVALID CODE LOCATION SD card removed during update.
E21
FILTER PAD/PAPER PROCEDURE ER-
ROR (Change Filter Pad or Paper) 25 hour timer has expired or dirty fi lter logic has activated.
E22 OIL IN PAN ERROR The MIB has detected oil may be in the pan.
E23 CLOGGED DRAIN (Gas) Vat did not empty during fi ltration.
E24
OIL RETURN (level) SENSOR FAILED
(Gas) Oil return sensor may have failed.
E25 RECOVERY FAULT Recovery time exceeded maximum time limit.
E26
M3000 ONLY
RECOVERY FAULT CALL SERVICE
Recovery time exceeded maximum time limit for two or
more cycles.
E27 LOW TEMP ALARM
Oil temperature has dropped lower than 15°F (8°C) in idle
mode or 45°F (25°C) in cook mode.
E28
FilterQuick3000 ONLY
HIGH TEMP ALARM
Oil temperature has risen 40°F (22.2°C) higher than
setpoint. If temperature continues to rise, the high limit
will shut the power off at 425°F (218°C) Non-CE or 395°F
(202°C) CE.
LOV/FQ Error Codes