17
1.
Switch the power source mains switch
to the “O” position
2.
Remove the wirefeeder housing cover
3.
Plug the hosepack strain relief device
into the recess provided, pull back
and screw in place
4.
Screw gas hose hexagon nut onto the
wirefeeder gas connector and tighten
5.
Place control cable and positive lead
through the housing bushing
6.
Connect the interconnecting hose-
pack control plug (16-pin) the right
way round
Fig.23 Fitting interconnecting hosepack to VR
3000 wirefeeder
Fitting intercon-
necting hosepack
to VR 3000
wirefeeder
7.
Screw the positive lead cable lug with its screw and shim to the bolt
8.
Remove the blanking covers from the front of the wirefeeder
9.
Place the water flow and return hoses through the housing bushing
10. Unscrew the plastic nuts from the couplings on the water flow and return hoses
11. Fit water flow and return hose couplings to the front and secure using plastic nuts
12. Fit the wirefeeder housing cover
1.
Switch the power source mains switch
to the “O” position
2.
Remove the wirefeeder housing cover
3.
Place water hoses, control cable and
positive lead through the housing
bushing
4.
Screw the hosepack strain relief
device in place
5.
Connect the interconnecting hose-
pack control plug (16-pin) the right
way round
6.
Screw the positive lead cable lug with
its screw and shim to the bolt
7.
Screw gas hose hexagon nut onto the
wirefeeder gas connector and tighten
Fig.24 Fitting interconnecting hosepack to VR
3300 wirefeeder
Fitting intercon-
necting hosepack
to VR 3300
wirefeeder
8.
Remove the blanking covers from the front of the wirefeeder
9.
Unscrew the plastic nuts from the couplings on the water flow and return hoses
10. Fit water flow and return hose couplings to the front and secure using plastic nuts
11. Fit the wirefeeder housing cover
