Fronius TPS/i Robotics TWIN Push, Operating Instructions Manual

Page: 92 / 108

92
38
It is not possible to purge the welding torch
Cause Torch hosepack not present or not connected correctly
Remedy Check the connection between the torch hosepack and the TWIN wirefeeder;
if the torch hosepack is connected correctly, inform the service team
16768
Welding process does not start
Cause: The interconnecting hosepack connections have been mixed up
Remedy: Connect the interconnecting hosepacks to the TWIN wirefeeder correctly (ob -
serve markings 1 and 2)
16769
Welding process does not start
Cause: The torch hosepacks have been mixed up
Remedy Connect the torch hosepacks to the TWIN wirefeeder correctly (observe
markings 1 and 2)
18229
Welding process does not start
Cause: The second power source is not ready
Remedy: Check whether the second power source is switched on;
check whether the second power source is connected to the TWIN Controller.
18230
Welding process does not start
Cause: Power sources are not synchronized
Remedy: Check whether the SpeedNet cable is connected to both power sources and
the TWIN Controller correctly
18231
Welding process does not start
Cause: The power source is connected to the wrong port on the TWIN Controller
Remedy: Check that power source 1 is connected to port 1 and power source 2 is con -
nected to port 2 on the TWIN Controller
18232
It is not possible to thread the wire or weld (in TWIN mode)
Cause: Single welding torch on a TWIN hosepack
Remedy: Select single mode or switch to a TWIN welding torch