Fronius Robacta TSS /i, Operating Instructions Manual, Page: 89 / 100

Troubleshooting
Detailed Informa-
tion on the
Optional Equip-
ment
NOTE!
For detailed information on the optional equipment, consult the available installa-
tion instructions or Operating Instructions for the optional equipment.
Troubleshooting Make a note of the serial number and configuration of the device, and provide the ser-
vice team with a detailed error description if:
-
Errors occur that are not covered in this document
- The troubleshooting measures provided in this document are unsuccessful
Parting agent is not injected
Parting agent container is empty
Insert new parting agent canister
Injection quantity too low
Set injection quantity (injection time)
Intake filter in "Robacta Reamer" parting agent container dirty
Blow out the intake filter in the "Robacta Reamer" parting agent container
from the inside out with compressed air using the intake hose:
*
2
3
4 1
Parting agent hose kinked
Remove kink, if necessary replace hose
Parting agent pump faulty
Contact After-Sales Service
No signal at the parting agent pump
Check programming;
Check connections to the robot control unit
Non-return value faulty
Contact After-Sales Service
Compressed air supply interrupted
Set up the compressed air supply
Compressed air supply line faulty or dirty
Clean compressed air supply line and replace if necessary
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
89
EN-US