Fronius Robacta TSS /i, Operating Instructions Manual, Page: 38 / 100

Bolting the Welding Torch Service Station to the
Surface
Bolting the Weld-
ing Torch Service
Station to the
Surface
WARNING!
Danger due to the welding torch service station toppling over.
It can cause injuries.
▶
Even out any unevenness in the floor
▶
Set the service station up on an even, solid, and vibration-free surface or a corres-
ponding base
▶
Only set up the service station so that it is horizontal
▶
Use four screws to anchor the service station to the surface
NOTE!
Depending on the surface, different dowels and screws may be required to anchor
the service station to the surface.
Therefore, dowels and screws are not part of the scope of supply for the service station.
The system installer is responsible for selecting the proper dowels and screws.
2
2
2
2
3
1
1
Position the service station
2
Use four dowels and four screws
appropriate for the surface to anchor
the service station to the surface
3
Ground the service station at its base
38