Fronius MagicWave 1700 Job, Operating Instructions Manual, Page: 73 / 148

73
EN
Increase the tilt angle of the torch and
actuate the torch trigger according to
the mode you have selected
The arc ignites without the electrode tou -
ching down on the workpiece.
Tilt the torch back into the normal posi -
tion
Carry out welding
Touchdown igni -
tion
If the HFt setup parameter is set to OFF, HF ignition is deactivated. The welding arc is ig -
nited by touching the workpiece with the tungsten electrode.
Procedure for igniting the arc using touchdown ignition:
Place the gas nozzle down on the igni -
tion location so that there is a gap of
approx. 2 to 3 mm (5/64 to 1/8 in.) bet -
ween the tungsten electrode and the
workpiece
2
3
4
1