Worktop
Welding point
Frame
Installation of the controls
Warning: Make sure that the controls are well ventilated. ( Max. Temperature inside the controls 60ºC )
Warning: If installing from the rear, access for after sales service must be provided.
4.2 Operation
Remove any remains of packaging and strip plastic coating. Remove the lid of the tank. Take the basket out of
the tank. Clean the appliance and the accessories with a non caustic cleaning agent, suitable for use in a food
area. CLOSE THE DRAIN VALVE. Fill the tank with oil to the MAX. level or place the fat for frying on the heating
elements. The MIN/MAX level is visible inside of the tank.
WARNING
The appliance is not equipped with a device to melt fat. When using fat for the first time, melt it beforehand
in a separate saucepan.
The next time you use the fryer, proceed as follows:
Make a few holes in the solidified fat down to the level of the heating elements. Turn the thermostat knob to a
maximum of 100°C. Heat for one minute, then turn the knob back to 0. Repeat this operation until the fat has
become liquid.
