15
Always protect the plug from contamination. If there is a
deposit which cannot be completely removed, the fusion
plugs must be replaced.
- Prepare the fitting and pipes for fusion in accordance with the assembly
instructions
- Ensure that the contact pins on the fitting are accessible for connection of
the fusion plugs
- Connect up the power supply (mains or generator)
- If using a generator start it up first and allow to warm up for 30 seconds
- Switch on the master switch (1)
- Connect the fusion plugs to the contact pins on the fitting
4.5
Reading in the bar code
IMPORTANT ! It is not acceptable to read in the bar code label from
another sort of fitting instead. After ending the read-in
process the reader wand must be replaced in the reader
wand pouch immediately to avoid damage and contami-
nation to the tip of the wand.
If there is a bar code label stuck onto the fitting this should always be used.
If the bar code label on the fitting being fused is illegible due to damage,
an identical fitting from the same
manufacturer with a legible bar code
label should be used.
Hold the reader wand slightly slanting and slightly inclined (like a pencil) and
place it on the fitting in front of the bar code. Now move the reader wand
quickly across the whole label and a little beyond. The reading can be done
from left to right or from right to left. When this has been done correctly the
machine will confirm it with a signal tone. If the reading in is not successful
first time try again, if necessary at a different angle or speed.
