31
5.9.1.3
Continuous number and Seam number
Use the MENU button to access submenu „ID
data“. Press the START button and use the arrow
buttons (up/down) to access the display which gives
the continuous number of the fusion processes car-
ried out by you. This number is allocated automati-
cally by the unit and cannot be changed. The conti-
nuous number is allocated to the appropriate
activated commission number.
Pressing the START button allows you to allocate a
number chosen by you („Seam number“) to your
fusion process. Symbols are chosen by using the
arrow buttons. Use the START button to save this
number and the STOP button to exit the submenu.
5.9.1.4
GPS 1 - 3
Use the MENU button to access submenu „ID
Data“. Press the START button and use the arrow
buttons (up/down) to access the screen where
you are able to enter the coordinates of the fusion
processes carried out by you (GPS 1, GPS 2 and
GPS 3). Symbols are chosen by using the arrow but-
tons. Use the START button to save this number and
the STOP button to exit the submenu. You will need
an appropriate device for calculating the GPS data.
5.9.2
Traceability barcodes/
Pipe number/Pipe length
IMPORTANT!
It is possible to enter traceability data only when
documentation and “Traceability” function and/
or “Pipe number and/or “Pipe length” are
switched on.
Reading in of traceability barcodes is activated after
the fusion barcode of the fitting to be fused has
been entered. A request to enter the traceability
barcode of the fitting appears in the display
(„FITTING:
T-CODE“). Once you have entered this
you will be requested to enter the traceability
barcode of Component 1 („COMPONENT 1:
FT_2377e_II_07_GB.qxd 13.02.2007 12:31 Uhr Seite 31
Summary of Contents for FRIAMAT BASIC ECO
Page 1: ...Operating Instructions FRIAMAT FRIAMAT FRIAMAT...
Page 41: ...41...
Page 42: ...42...
Page 43: ...43...