14
3.2
Enter barcode
WARNING!
Take reader wand out of reader wand pouch by
opening the pouch, grasping the reader wand at
its end/anti-kink sleeve (black) and taking it out.
It is not permitted to read in the barcode of a
different type of fitting. On completion of the
reading in process the reader wand must be
returned to its pouch immediately in order to
avoid damage and contamination of the reader
wand tip.
IMPORTANT!
The fusion plugs of your FRIAMAT
®
-model must
be connected with the contact plugs of the fitting
as a resistance check is carried out immediately
on reading in the barcode. An error message will
appear if there is “non contact”. Please also
ensure that the fusion plugs of your FRIAMAT
®
-
model are attached to the contact pins on the fit-
ting across the entire internal contact width.
Once the barcode label has been attached to the
fitting, this is the only one to use. If the barcode label
of the fitting to be fused is not legible due to damage,
a fitting with a legible barcode label
built in the
same way by the same manufacturer
must be
used.
Hold the reader wand slightly slanted and slightly
inclined (like a pencil) and place it on the fitting in
front of the barcode. Now move the reader wand
quickly across the whole label and a little way
beyond. The reading can be done from right to left
or the other way around. If this has been done
correctly, the unit will confirm the reading with a
signal. If reading in is not successful straight away,
try again, if necessary at a different angle or speed.
FT_2377e_II_07_GB.qxd 13.02.2007 12:31 Uhr Seite 14
Summary of Contents for FRIAMAT BASIC ECO
Page 1: ...Operating Instructions FRIAMAT FRIAMAT FRIAMAT...
Page 41: ...41...
Page 42: ...42...
Page 43: ...43...
