FRIATEC FRIAMAT BASIC ECO, Operating Instructions Manual

Page: 30 / 44

30
The term “ID data” includes data which you can
allocate to your imminent fusion process: commis-
sion number, operator pass, continuous number
seam number and GPS data (1-3). The following
sections describe this additional information.
IMPORTANT!
Entering commission numbers and seam num-
bers is possible only when documentation and
the function “Commission number” and/or
“Seam number” are switched on.
5.9.1.1 Commission number
Press the MENU button to access submenu „ID
Data“. Press the START button to bring up „Com-
mission Number“ in the top line of the display. On
entering an commission number for the first time the
following appears „########################“.
The first digit flashes. By moving the arrow buttons
you will be able to enter your commission number.
Use the START button to save this number and the
STOP button to exit the submenu.
If you have already entered one or several commis-
sion numbers, you will be able to choose in „ID
Data“ in submenu „Commission number“ between
„CHANGE“ (changing of last entered commission
number), „NEW“ (entering a new commission num-
ber), and „SELECTION“ (selecting an commission
number from the last 20 commission numbers
entered) by pressing the START button and using
the arrow buttons (up/down). Data entry, saving and
exiting this submenu takes place as described
above.
5.9.1.2 Operator pass
Use the MENU button to access submenu „ID
Data“. Press the START button and use the arrow
buttons (up/down) to access the display informing
you whether and which fusion operator has been
entered (if no operator pass has been activated,
there is no display in this screen). The fusion opera-
tor cannot be changed manually, i.e. by using but-
tons; if you wish to enter a new fusion operator you
will need an appropriate operator pass (see section
5.4.2).
FT_2377e_II_07_GB.qxd 13.02.2007 12:31 Uhr Seite 30