MOVING
31 March, 1999
3-4
3.6 MOVING
To move a previously installed laser printer, follow the instructions below.
1. The printer weighs about 62 kg. Always be sure two or more people move the
printer.
2. Keep the printer horizontal during transportation. (Do not concentrate the load
on any one part of the base.)
3. Before moving the printer, pack the printer using the factory-supplied
cushioning materials whenever possible.
4. Remove the oil from the fusing unit.
1) Remove the oil bottle from the printer before moving.
2) Drain the oil off the fusing unit. Refer
to the Fusing section of Chapter 6
(Replacement and Adjustment
Procedures) to remove the oil
supply unit of the fusing unit.
Gradually tilt the oil sump to move
oil from oil sump [A] to the oil bottle
[B].
3) After moving the oil to the oil bottle,
wipe the oil sump and oil bottle with
a cloth.
ø
CAUTION
Make sure that no fusing oil remains in the printer. Remove the oil and
clean the oil sump and oil bottle as explained above. Otherwise, the oil may
spread inside the printer while moving it.
5. Insert cushioning material [E] between
the DTM [C] and the left side panel [D]
to fix the DTM in place.
6. Replace the fusing unit and cover.
7. Clean the printer before re-packing.
8. Remove paper from the paper tray.
9. Remove the optional paper tray.
10. Tape the left, right, front, rear, and top
covers and the paper tray.
G024I500.WMF
G024I501.WMF
[A]
[B]
[C]
[D]
[E]
