FRENCH FITNESS MSC10, Owner'S Manual

Page: 18 / 54

STEP 8 (See Diagram 8 & Cable Loop Diagram)
A.) Attach one end of the Sliding Weight Post Cable 3710 (#49) to the open bracket on the
Sliding Weight Post (#19). Secure it with one Hex Bolt M10×25 (#88), two Washers φ 10
(#103), and one Nut M10 (#108).
B.) Draw the Cable upward to the Pulley on the top of the Upper Frame (#17) previously
installed in Step-4.
C.) Draw the Cable around the Pulley then downward. Install a Small Pulley (#51) to the
Double Floating Pulley Bracket (#34). Secure it with one Hex Bolt M10×45 (#92), two
Washers
φ 10 (#103), and one Nut M10 (#108).
D.) Draw the Cable around the Pulley then to the Triple Floating Pulley Bracket (#36)
previously installed in Step-6.
E.) Install a Small Pulley to the Bracket. Draw the Cable around the Small Pulley then
downward to the open bracket on the Rear Vertical Frame (#10).
F.) Install a Pulley to the bracket. Draw the Cable around the Pulley then upward.
G.) Connect the Cable to a Short Chain (#106) with a Hook (#52). Connect the Short Chain
to the Single Floating Pulley Bracket (#33) previously installed in Step-7. Secure the
Chain with one Hex Bolt M10×30 (#94), two Washers
φ 10 (#103), and one Nut M10
(#108).
H.) After completing the entire cable installations, come back to this Short Chain to adjust
the tension of the Cable system by adjusting the length of the Chain.
I.) Install two Olympic Sleeves (#58) and Spring Clips (#55) onto the Sliding Weight Post
(#19).
DIAGRAM 8
50
17
49
36
51
34
103
92
94
108
106
52
88
92
50
103
103
19
58
55
17