FRENCH FITNESS MSC10, Owner'S Manual

Page: 15 / 54

STEP 6 (See Diagram 6& Cable Loop Diagram)
A.) Install the Ball Stopper, Big Washer and the U-shaped Connector to one end of the
Upper Cable 6895 (#47). Secure it with one Hex Bolt M10×35 (#93) ， Nut M10 (#108)
and two Washers φ 10 (#103).
Insert the other end of Cable through the left Cross-over Swivel Pulley Bracket (#38).
Attach a Pulley (#50) to the Swivel Bracket and secure it with one Hex Bolt M10×45
(#92), two Washers
φ 10 (#103), and one Nut M10 (#108). Draw the Cable over the
Pulley and pull it towards the back of the machine.
Draw the Cable along the Left Upper Frame (#8) to the opening on the rear of the Frame.
Drop the cable through the opening.
Attach a Pulley to the opening. Secure it with one Hex Bolt M10×65 (#91), two Pulley
Bushings (#66), and one Nut M10 (#108). Draw the Cable around the Pulley then
downward.
Install the Little Single Floating Pulley Bracket (#37) to the bottom of the Upper Frame
(#17). Secure it with one Hex Bolt M10×30 (#94), two Washers
φ 10 (#103), and one Nut
M10 (#108).
Attach one Small Pulley (#51) to the Triple Floating Pulley Bracket (#36) . Draw the
Cable around the Pulley. Secure it to the Bracket with one Hex Bolt M10×70 (#90) and
one Washer
φ 10 (#103) from one side temporarily. Then Draw the Cable upward to the
bracket underneath the Upper Frame (#17).
B.)
C.)
D.)
E.)
F.)
G.) Install a Small Pulley to the Little Single Floating Pulley Bracket (#37). Draw the Cable
around the Pulley. Secure it to the Bracket with one Hex Bolt M10×45 (#92), two
Washers
φ 10 (#103), and one Nut M10 (#108). Draw the Cable downward to the Triple
Floating Pulley Bracket.
Install another Small Pulley to the Triple Floating Pulley Bracket (#36). Draw the Cable
around the Pulley. Secure the two Pulleys to the Bracket with one Hex Bolt M10×70 (#90)
and one Washer
φ 10 (#103) previously installed in Procedure F above, and another
Washer φ 10 and one Nut M10 (#108).
Draw the Cable upward to the opening on the rear of Right Upper Frame (#9). Let the
Triple Floating Pulley Bracket hanging for now.
Install a Pulley to the opening. Draw the Cable over the Pulley along the top of the Right
Upper Frame (#9) through the cable sleeve to the right Cross-over Swivel Pulley
Bracket(#38). Install a Pulley to the Bracket.
Install the Ball Stopper, Big Washer and the U-shaped Connector to the end of Cable.
Secure it with one Hex Bolt M10×35 (#93)
， Nut M10 (#108) and two Washers φ 10
(#103).Connect a Single Handle Strap (#81) to each end of the Cable with a Hook (#52).
When using the Lat Bar, remove one of the Strap and connect the Lat Bar to end of the
Cable with a Short Chain (#53) and two Hooks (#52).
H.)
I.)
J.)
K.)
L.)
14