Freggia DWCI 6159, User Manual

Page: 14 / 58

14
MAINTENANCE AND CLEANING
14
MAINTENANCE AND CLEANING
CLEANING THE MACHINE IN REGULAR INTERVALS PROLONGS
THE MACHINE’S SERVICE LIFE.
• OIL AND LIME MAY ACCUMULATE IN THE MACHINE’S WASHING SECTION.
IN CASE OF SUCH ACCUMULATION;
• Fill the detergent compartment without loading any dishes into the
machine, select a programme that runs at high temperature, and start the
machine. In case of insufficiency, use special cleansing material available
in the market. (Cleansing material produced special to machines by
detergent producers.)
• CLEANING THE SEALS IN THE MACHINE DOOR
• To clean any accumulated residues in the door seals, wipe the seals
regularly by using a dampened cloth.
• CLEANING THE MACHINE
Clean the filters and spray arms at least once a week.
Unplug your machine and turn off its tap before starting the cleaning.
Do not use hard materials when cleaning your machine. Wipe with a fine cleaning
material and a dampened cloth.
FILTERS
Check if any food wastes have remained on the coarse and fine filters.
If any food wastes are left, remove the filters and clean them thoroughly under the
water tap.
a. Micro Filter
b. Coarse Filter
c. Metal/Plastic Filter
To remove and clean the filter
combination, turn it counter
clockwise and take it out by lifting
upwards. 1 Pull and remove the
metal/plastic filter. 3 Then pull
the coarse filter out of the micro
filter.2 Rinse it with lots of water
under the tap.
Refit the metal/plastic filter. Insert the coarse filter into the micro filter in a way that
the marks will correspond to one another. Attach micro filter into the metal/plastic
filter and turn to the direction of arrow and it is locked when the arrow on micro filter
can be seen from across. 4
• Never use your dishwasher without any filter.
• Incorrect fitting of the filter will reduce the washing effectiveness.
• Clean filters are very important in terms of the proper running of the
machine.
SPRAY ARMS
Check whether or not the holes for the upper
and lower spray arms are clogged. If there is any
clogging, remove the spray arms and clean them
under water.
You can remove the lower spray arm by pulling it
upwards, while the upper spray arm nut can be
removed by turning the nut to the left.
Be sure that the nut is perfectly tightened when
refitting the upper spray arm.
HOSE FILTER
Water is prevented by the inlet hose filter so as to avoid any damage to your machine
because of any contamination (sand, clay, rust etc.) that might be occasionally carried
in through the mains water supply or the indoor plumbing, and to forestall such
complaints as yellowing and formation of deposits after washing. Check the filter and
the hose from time to time and clean them if necessary. To clean the filter, first turn off
your tap and then remove the hose. After removing the filter from the hose, clean it
under the tap. Insert the cleaned filter back into its place inside the hose. Refit the hose.