R
Assembly
Note:
1.
Read the manual carefully before beginning assembly and make sure you understand each step in the
process. If you have any questions, contact your distributor, or contact us at freewing@sz-
freewing.com.
2.
As a reference, this manual will assemble the airplane in the high wing tricycle landing gear
configuration as well as
explain
how to reconfigure the airplane afterwards.
3.
Before assembly, please refer to P 18 for proper screw assignments.
Find the parts (see the photo) needed to install the
wing onto the fuselage.
Feed the servo wire through the hole in the
center
section
, then slip the carbon fiber rod into the round
hole in front of the wire hole and slide the rod up so
that the attachment points are visible through the
points on the wing. Make sure that the servo wires
are not pinched between the wing and the
center
section
.
Anchor the wing to the
center section
with the two
provided screws. Do not over tighten the screws!
Repeat these steps for the other wing.
