R
Feed the aileron and flap cables (if installed) through
the fuselage to the receiver and plug them in. When
securing the center section to the fuselage, take care
not to pinch the wires in between the two parts.
Install the canopy. It will snap into place as its held
on with magnets. Note the plastic strap on the
trailing edge of the canopy. Pull up on it to remove
the canopy to get access to the hatch.
Tail Dragger Landing Gear Assembly
Remove the spinner, propeller, backing plate and
the plastic cowling.
Remove the canopy and loosen the screw holding the
nose gear control rod inside the servo control arm's
anchor point. See the photo.
There are four screws that hold the nose gear onto
the fuselage, loosen these and remove the plate.