R
Once cut, carefully bend the flap
down and
back to neutral several
times to loosen it up.
Remove the wing
s from the center section by
removing the four screws and sliding the wings
out.
After installing the flap servos, feed the servo
wires through the wire channels and into the
center section.
After the glue holding the flap servos in place has
dried, attach the control rods to the servo control
horns.
Join the two flap servo cables with a 'Y' harness
and plug the end of the 'Y' harness into an
available channel on the receiver.
Don't forget to plug the aileron cable back into the
receiver as well!
