Freeview T2400, Important Information Manual

Page: 17 / 76

17
< Program Remote Control for TV >
To switch the RCU between TV Control mode and PVR Control mode:
1. Press the TV or STB button at the bottom of the remote control.
To check which RCU control mode is active:
1. Simply look at the TV / STB buttons, which light up whenever one of the other remote
control buttons is pressed.
2. In TV Control mode, the TV button will only illuminate when the button pressed actually
sends a remote signal to the TV.
As an example - when the RCU is in TV Control mode:
1. If the VOL+ / - buttons are pressed, the TV button lights up.
2. Pressing the STOP button is not relevant to the TV so the TV button doesn‟t light up.
Programming the RCU to Control Your TV (Entering an RCU code from the code list):
1. Look in the code table (found in the A-3. Remote Control Code List by TV Manufacturer) for
your TV.
2. Manufacturers often use several codes for different TV models, so you may need to try a
number of codes.
3. Press - and hold - both the OK and TV buttons on the RCU for 3 seconds. The TV button will
turn on.
4. Enter the 4-digit code.
5. If the remote code is correctly recognized, the TV button will turn off. If the TV button still
turns on, please re-enter the code.
6. When the TV button turns off, press the OK button.
7. The TV button will flash three times and the programming will be finished.
8. Test your setup by sending a few commands to the TV.
9. If the TV doesn‟t respond, repeat the procedure with another code.
Resetting the Remote Control Unit
1. Input code „0000‟ to reset the remote control to the original factory setting.
2. The RCU does not support all TV models.
TVs are often made by other manufacturers, and therefore use different codes to
those listed for the manufacturer (brand).
If no buttons are pressed for 5 seconds, the setup (learning) mode is cancelled.