Required Equipment
KT912F634UG User’s Guide Rev. 2.0 10/2013
6
Freescale Semiconductor, Inc.
Archive Information
Archive Information
4.3
Acronyms
5
Required Equipment
•
PC Computer running Windows XP or higher
•
12V Power Supply
•
USB Cable (supplied)
6
Setup Guide
6.1
Hardware Setup
Setup and connections for the KIT912F634EVME are straightforward.
The KIT912F634EVME requires a connection to the power supply and a connection to the PC or notebook via
the USB cable.
Figure 2
depicts a complete setup.
Follow these steps to set up the board:
1. Plug the USB cable into the connector J101 and connect the other end of the cable to the PC or notebook.
2. A basic jumper configuration is required to be able to use the KIT912F634EVME. See
Table 2
for details.
Table 3
provides a complete index of jumper settings.
3. Connect a laboratory power supply via banana connectors to the board, using J2 (V_S supply) and J3
(GND). Alternatively, the LIN connector can be used for powering the board. The supply voltage has to be
in the range of 8.0 to 18 V. When power is applied to the KIT912F634EVME, the green power-on LEDs D6
(+5.0 V), D7 (supply), and D8 (+2.5 V) are lit when power is present and the corresponding jumpers JP4,
JP8, JP9 are closed.
Table 1. Explanation of Acronyms
Acronym
Meaning
Acronym
Meaning
D2D
Die to Die bus
interface
MCU
Microcontroller Unit
BDM
Background Debug
Module
HS
High Side (switch)
EVB
Evaluation Board
LED
Light Emitting Diode
EVM
Evaluation Module
LIN
Local Interconnect
Network
ESD
Electrostatic
Discharge,
Electrostatic Sensitive
Device
LS
Low Side (switch)
GND
In this document: main
supply ground
PWM
Pulse Width
Modulation
GPIO
General Purpose
Input/Output
SCI
Serial Communication
Interface
GUI
Graphical User
Interface
TBDML
Turbo BDM Lite
ADC
Analog to Digital
Converter
