11
8
8. Orient the Bored 10-pound Weight (71), the
Tapped 10-pound Weight (42), the Top Weight
(9), and the Drop-down Weight (10) as shown.
Slide the Bored 10-pound Weight (71), the
Threaded 10-pound Weight (42), the Top
Weight (9), the two Upper Weight Bumpers
(16), the Drop-down Weight (10), and the two
25mm Snap Rings (39) onto the Weight Guides
(7).
Next, slide the two Weight Guide Bushings (18)
onto the upper ends of the Weight Guides (7).
Attach the two 25mm Snap Rings (39) to the
Weight Guide Bushings (18).
Then, tighten the two M8 x 35mm Set Screws
(19) into the Weight Guide Bushings (18).
9
9. Remove all parts (23, 29, 31, and 32) from the
pulley bracket on the Tower Frame (1).
Route the Cable (40) through the pulley bracket
and downward through the hole in the center of
the Tower Frame (1).
Attach the Small Pulley (23) inside the pulley
bracket with the M10 x 50mm Socket Bolt (29),
the two M10 Washers (31), and the M10
Locknut (32) that you just removed.
Make sure
that the Cable (40) is between the Small
Pulley and the rod on the pulley bracket.
10
16
16
19
19
18
18
7
9
32
1
31
23
Rod
31
29
40
39
71
42
Summary of Contents for F812.0
Page 22: ...22 NOTES...
Page 23: ...23 NOTES...
