![background image](http://html1.mh-extra.com/html/freecom/tapeware-lto-460i/tapeware-lto-460i_manual_2329752032.webp)
30
30
Problems encountered during installation
Unpacking
The server requires mounting hardware
Does the SCSI ID need changing?
How should the SCSI bus be terminated?
Description
Further information
Some parts appear to be missing or
damaged.
Contact your vendor if any parts need replacing.
Description
Further information
Additional parts may be required for
fitting the tape drive into the server.
Mounting hardware may need to be ordered
separately through your tape drive vendor or
computer manufacturer.
Description
Further information
SCSI ID 3 is already in use.
The Ultrium Generation 2 internal drive has its
SCSI ID set to 3 by default. This should be left
unchanged unless this number is already in use.
Full instructions on how to change the SCSI ID are
given on page 9.
Description
Further information
It is unclear if the bus is already
terminated or where an additional
terminator should be placed.
Both ends of a SCSI bus must be terminated.
Typically, when connecting an internal drive to the
ribbon cable already inside your server then both
the host bus adapter and the end of the ribbon
cable will already be terminated and no further
action is required.
gen2 internal oem.fm Page 30 Thursday, February 13, 2003 3:03 PM
Summary of Contents for TapeWare LTO 460i
