11
Contents
Read the “Pre-Installation” and “Installing the tape drive” sections if you have to install or
replace your Ultrium Generation 2 tape drive. If you have purchased your tape drive pre-
installed in a server, go directly to the operating and troubleshooting information commencing
on page 23.
Pre-Installation
Before you start
page 3
Backup software and drivers
page 5
Installing the tape drive
Step 1: Check the SCSI connection
page 7
Step 2: Check the drive’s SCSI ID
page 9
Step 3: Prepare the mounting bay
page 11
Step 4: Attach mounting hardware
page 13
Step 5: Install the drive
page 15
Step 6: Attach power and SCSI cables
page 17
Step 7: Secure the drive
page 19
Step 8: Verify installation
page 21
Using the tape drive
Your Ultrium Generation 2 tape drive
page 23
Use the correct media
page 25
Optimizing performance
page 27
Troubleshooting
page 29
Understanding the LEDs
page 33
Problems with cartridges
page 36
gen2 internal oem.fm Page 1 Thursday, February 13, 2003 3:03 PM
Summary of Contents for TapeWare LTO 460i
