Installing
jumper pins besides the ones for SCSI ID settings may be the cause of
damage or abnormal drive operation.
2. Installing the Drive
2.1 Before Installation
Before installing the drive, please note the following points.
I your will need the following:
l
SCSI interface board and manual (The SCSI interface board is not included
with this product. You need to purchase it separately.)
l
Computer
manual (You need the manual in order to find out location of the
bus slot for installing the SCSI interface board.)
l
A head screw driver of a suitable size to fit the securing screws for the drive
unit.
l
Turn off all peripheral appliances of the computer, and the computer itself,
and disconnect their power cords from the wall sockets.
l
Discharge any static electricity by touching the computer covers etc.
2.2 SCSI ID Settings
Before installation, set SCSI ID on the rear panel. A single SCSI interface can
connect with a maximum of seven peripheral SCSI devices. When using multiple
SCSI devices, a different SCSI must be set for each of them.
Attention! If two peripheral devices use the same SCSI ID number, it will cause
the host computer to operate abnormally or fail to start up.
Terminator
SCSI ID
Reserve (Fixed OFF)
ON (When the jumper is attached)
OFF (When the jumper is removed)
Attention ! Before attaching or removing jumpers, make
power to the
rive is turned OFF.
Summary of Contents for Internal IDE
Page 1: ......
