![background image](http://html.mh-extra.com/html/freecom/internal-ide/internal-ide_manual_2329623018.webp)
Master/Slave setting is determined by jumper installation on the Jumper Con-
nector. The following table shows the possible jumper settings.
Name
MA
(Master)
Function
Drive set as Master (factory default)
Drive set as Slave
(Slave)
c s
Drive mode set by CSEL on the host
Select) IDE interface
A hard disk is normally installed as the Primary Master on the
interface. Other
peripheral devices such as hard drives and CD-ROMs are
then set differently.
2.3 Removing the Computer Cover
Make sure all peripheral devices of the computer and the computer itself are
turned off, and then removethe cover.
the manual
computer for
details about removing the cover.
There may be sharp edges inside the computer so care must be taken to avoid
injury. (See fig.
10)
2.4 Mounting the Drive
1.
Remove the 5 inch drive bay panel from the computer. Refer to the manual
for the computer for details.
2. Insert the drive unit into the bay. Do not apply excessive pressure to the
cables inside the computer.
Secure the drive with the screws provided. If there is not enough space
behind the drive, connect the IDE cables etc. before securing the drive.
(See fig.
1 I)
2.5 Connecting the Power Connector
Connect the power cable from the computer’s power supply to the socket on the
drive unit, fitting the connector snugly into the socket. If there is no spare power
cable available in the computer, you will have to purchase a splitter cable of a
suitable type. (See fig.
II)
1 6
Summary of Contents for Internal IDE
Page 1: ......