WLA200 Rev140407
16
Install Remote Light Driver
The remote light driver is water proof to allow for flexibility in the mounting
location.
1. Measure and mark mounting location for light driver. Make sure there is
clearance for driver and cable before drilling holes. Refer to Figure 5 for
dimensions.
2. Drill and tap two 10-32 holes.
3. Secure remote light driver with two screws.
4. Connect cable and wires. (Refer to Wiring section.)
Install Buzzer
Install the buzzer close to the TankVision so the audible warning is easily associated
with the TankVision. A cutout hole diameter of 1-1/4" is required. ( Refer to the wiring
section.)
Figure 6. Remote Light Driver
2 3/4"
1 3/8"
3 1/2"
4"
1"
Summary of Contents for TankVision WLA200
Page 30: ...WLA200 Rev140407 30 NOTES...
Page 31: ...WLA200 Rev140407 31 NOTES...
Page 32: ...WLA200 Rev140407 32...
