FRC FDA700 for Delta Winding, Instruction Manual

Page: 6 / 20

FDA700 Rev160509
6
INSTALLATION
Ensure that the generator power rating and the display rating match. Refer to
Programming Section.
Install Display Module
1. Measure and mark mounting location for display module panel cutout and mounting
screw holes. Make sure there is clearance behind the panel for the module and
cables before cutting holes. Refer to Figure 2 for layout and dimensions.
2. Cut out a 3 3/4" mounting hole in panel.
3. Drill four holes, clearance or tapped, for #10 mounting screws.
4. Place display module in position and secure with screws.
5. Connect cable at rear of the display module. (Refer to Wiring Section.)
Install Signal Interface Module
This module is mounted close to the current sensors and voltage transformers
so the cable runs are short. Current and voltage information is passed to the display
module over a two wire datalink.
1. Measure and mark mounting location for control box mounting screw holes.
Make sure there is clearance for the box and cables before drilling. Refer to
Figure 3 for layout and dimensions.
2. Drill four holes, clearance or tapped, for #8 mounting screws.
4. Place box in position and secure with screws.
5. Connect cables at top of the box. (Refer to Wiring Section.)