5
INSTRUCTIONS FOR ASSEMBLY
1.
Insert shaft into the coupling with the key in the
keyway. Ensure shaft is seated completely into the
coupling.
2.
Your support table set up may vary, but we
recommend having access below the table to secure
shaft to build fixture (step 4).
3.
Install the motor bracket to the build fixture by
aligning bracket holes with four hubs on fixture. Install
the shaft onto the fixture ensuring the coupling is
completely seated on the shaft stub.
4.
Insert assembly fixture bolt from bottom of fixture and
screw into coupling with Allen wrench until tight.
5.
Once the bracket and shaft are installed, insert the
lower impeller (with large collet nut) onto the shaft.
PUMP SIZE
SCREW LENGTH
6”
5 7/8”
7 1/2”
8 / 10”
8 1/2”
1
2
3
4
5
