10
INSTRUCTIONS FOR ASSEMBLY
24.
Use the small flat-head screwdriver to gently
raise the strap on the opposite side of the cable
guard.
25.
Gently tap the other tab under the strap.
Remove the screwdriver after the cable guard
tab has started under the strap.
26.
The cable guard should be centered between
the two straps.
27.
Repeat steps 23–26 for all the tabs except
the top two.
28.
After all but the top two tabs have been
installed, gently tap the top end of the cable
guard down toward the motor bracket.
• Be careful not to damage or bend the cable
guard.
29.
Apply pressure to the end of the cable guard
while tapping on the top side of the tabs close
to the motor bracket. This will allow for the end
of the cable guard to slide under the motor
bracket ears.
30.
Gently tap the cable guard to drive one of the
top two cable guard tabs under the strap.
25
24
28
29
30
29
29
26
27
