background image

4

LIMITED WARRANTY*

THIS WARRANTY SETS FORTH THE COMPANY’S SOLE OBLIGATION AND PURCHASER’S EXCLUSIVE REMEDY FOR 
DEFECTIVE PRODUCT.

Franklin Electric Company, Inc. and its subsidiaries (hereafter “the Company”) warrants that the products accompanied by this 
warranty are free from defects in material or workmanship of the Company. 
The Company has the right to inspect any product returned under warranty to confirm that the product contains a defect in 
material or workmanship. The Company shall have the sole right to choose whether to repair or replace defective equipment, 
parts, or components.
The buyer should return the product to the place of purchase for warranty consideration. Subject to the terms and conditions 
listed below, the Company will repair or replace to the buyer any portion of this product which proves defective due to materials or 
workmanship of the Company. 
The Company will consider products for warranty for 12 months from the date of installation or for 24 months from the date of 
manufacture, whichever occurs first. 
The Company shall IN NO EVENT be responsible or liable for the cost of field labor or other charges incurred by any customer in 
removing and/or affixing any product, part or component thereof.
The Company reserves the right to change or improve its products or any portions thereof without being obligated to provide 
such change or improvement to previously sold products. 
THIS WARRANTY DOES NOT APPLY TO products damaged by acts of God, including lightning, normal wear and tear, 
normal maintenance services and the parts used in connection with such service, or any other conditions beyond the control 
of the Company. 
THIS WARRANTY WILL IMMEDIATELY VOID if any of the following conditions arev found:
1. Product is used for purposes other than those for which it was designed and manufactured;
2. Product was not installed in accordance with applicable codes, ordinances and good trade practices;
3. Product was not installed by a Franklin Certified Contractor or Franklin Key Dealer; or
4. Product was damaged as a result of negligence, abuse, accident, misapplication, tampering, alteration, improper 
  installation, operation, maintenance or storage, nor to an excess of recommended maximums as set forth in the 
  product instructions.
NEITHER SELLER NOR THE COMPANY SHALL BE LIABLE FOR ANY INJURY, LOSS OR DAMAGE, DIRECT, INCIDENTAL OR 
CONSEQUENTIAL (INCLUDING, BUT NOT LIMITED TO, INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR LOST PROFITS, 
LOST SALES, INJURY TO PERSON OR PROPERTY, OR ANY OTHER INCIDENTAL OR CONSEQUENTIAL LOSS), ARISING OUT 
OF THE USE OR THE INABILITY TO USE THE PRODUCT, AND THE BUYER AGREES THAT NO OTHER REMEDY SHALL BE 
AVAILABLE TO IT. 
THE WARRANTY AND REMEDY DESCRIBED IN THIS LIMITED WARRANTY IS AN EXCLUSIVE WARRANTY AND REMEDY AND IS 
IN LIEU OF ANY OTHER WARRANTY OR REMEDY, EXPRESS OR IMPLIED, WHICH OTHER WARRANTIES AND REMEDIES ARE 
HEREBY EXPRESSLY EXCLUDED, INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF MERCHANTABILITY OR 
FITNESS FOR A PARTICULAR PURPOSE, TO THE EXTENT EITHER APPLIES TO A PRODUCT SHALL BE LIMITED IN DURATION 
TO THE PERIODS OF THE EXPRESSED WARRANTIES GIVEN ABOVE.
DISCLAIMER: Any oral statements about the product made by the seller, the Company, the representatives or any other parties, 
do not constitute warranties, shall not be relied upon by the buyer, and are not part of the contract for sale. Seller’s and the 
Company’s only obligation, and buyer’s only remedy, shall be the replacement and/or repair by the Company of the product as 
described above. Before using, the user shall determine the suitability of the product for his intended use, and user assumes all 
risk and liability whatsoever in connection therewith.
Some states and countries do not allow the exclusion or limitations on how long an implied warranty lasts or the exclusion or 
limitation of incidental or consequential damages, so the above exclusion or limitations may not apply to you. This warranty gives 
you specific legal rights, and you may also have other rights which vary from state to state and country to country.
*Contact Franklin Electric Co., Inc. Export Division for International Warranty.

9255 Coverdale Road

Fort Wayne, IN  46809

Tel: 260-824-2900
Fax: 260-824-2909 
www.franklinwater.com

Summary of Contents for FBSGF Series













Reviews: