![background image](http://html1.mh-extra.com/html/franke/fmy-98-p-bk/fmy-98-p-bk_user-manual_2327509014.webp)
14
REMOVING AND REFITTING THE DOOR
1.
To remove the door, open it fully and lower the
catches until they are in the unlock position�
b
a
2.
Close the door as much as you can�
Take a firm hold of the door with both hands – do not
hold it by the handle�
Simply remove the door by continuing to close it
while pulling it upwards at the same time until it is
released from its seating� Put the door to one side,
resting it on a soft surface�
a
b
~15°
3.
Refit the door by moving it towards the oven,
aligning the hooks of the hinges with their seating
and securing the upper part onto its seating�
4.
Lower the door and then open it fully�
Lower the catches into their original position: Make
sure that you lower them down completely�
b
a
Apply gentle pressure to check that the catches are in
the correct position�
“CLICK”
5.
Try closing the door and check to make sure that it
lines up with the control panel� If it does not, repeat
the steps above: The door could become damaged if
it does not work properly�
REPLACING THE LAMP
1.
Disconnect the oven from the power supply�
2.
� Remove the cover from the light, replace the bulb
and put the cover back on the light�
3.
Reconnect the oven to the power supply�
Please note: Only use 25-40W/230V type E-14, T300°C
incandescent lamps, or 20-40W/230 V type G9, T300°C
halogen lamps. The bulb used in the product is specifically
designed for domestic appliances and is not suitable for
general room lighting within the home (EC Regulation
244/2009). Light bulbs are available from our After-sales
Service.
If using halogen bulbs, do not handle them with your bare
hands as your fingerprints could cause damage. Do not use
the oven until the light cover has been refitted.