Franke FCE90M10B, User Manual

Page: 13 / 15

L
N
NB:
cooking times are approximate and may vary according to personal taste .When cooking using the grill or fan
assisted grill ,the dripping pan must always be placed on the 1st oven rack from the bottom .
Installation
Only a qualified person in compliance with the instructions provided must install the appliance.
Appliance
are fully assembled as in normal operation without any parts removed .The manufacturer declines all responsibility
for improper installation, which may harm persons and animals and damage property.
Important:
- The power supply to the appliance must be cut off before any adjustments or maintenance work is
done on it;
- Air duct is supposed to use in Ventilation.
Installation of Built-in Ovens
The oven must not be installed behind a decorative door in order to avoid overheating.
In order to ensure that the built-in appliance functions properly, the cabinet containing it must be appropriate .The
figure below gives the dimensions of the cut-out for installation under the counter .
In order to ensure adequate ventilation ,the back panel of the cabinet unit must be removed .
The oven must have a 40mm clearance between the oven and the rear timber panel.
The panels of the adjacent cabinets must be made of heat-resistant material .In particular ,cabinets with a veneer
exterior must be assembled with glues which can withstand temperatures of up to 100
℃
.
In compliance with current safety standards, contact with the electrical parts of the oven must not be possible once it
has been installed.
The oven must be secured by 4 screws to the cabinet.
Electrical Connection
Those ovens equipped with a three-pole power supply cable are designed to operate with an alternating
current .The wire for earthling the appliance is yellow-green in color.
Fitting on a Power Supply Cable
Opening the terminal board:
·Using a screwdriver, prize the bolt on the side tabs of the
terminal board cover ;
·Unscrew the bolt, pull open the cover of the terminal board .
To install the cable, proceed as follows:
· Remove the wire clamp screw and the three contact screws
L-N
–
·Fasten the wires beneath the screw heads using the following color scheme :
Blue (N) Brown (L) Yellow-Gre
15 AMP Fuse is Required
en
·Fasten the supply cable in place with the clamp and close the cover of the terminal board .
Connecting the supply cable to the mains
Install a standardized plug corresponding to the load indicated on the data plate. When connecting the cable directly
to the mains, install an omni polar circuit breaker with a minimum contact opening of 3 mm between the appliance
482
485