BBR Operating Manual
Page 12
To turn ON the BBR Case:
§
Verify power cord is plugged in to a working 120-volt/60-Hz power
outlet.
§
Turn ON main power switch located upper-left on
the
case front, next to the temperature display. Red switch light comes
on when power is ON.
§
Compressor and interior display light should come on when switch
is activated and bringing the case down to target temperature of
34° to 40° F. This process will take about 30 minutes, depending on
room temperature and humidity.
Temperature Display & Temperature Adjustments:
The BBR wall mounted Bottled Beverage Refrigerator is designed to
maintain the recommended refrigerated product storage temperature
range of 34° to 40° F. The internal thermostat is calibrated, set and tested
with Factory Settings: Cut-Out at 37.9
º and Cut-In at 39.7º F
. This
thermostat should not require adjustment unless the BBR unit is exposed
to excess room temperature, high humidity or full, direct sunshine, for
extended periods.
Monitoring Operating Temperature:
The digital front temperature display shows
the actual unit operating temperature at all
times. If adjustment becomes necessary, the
two buttons on the digital temperature
display are used to adjust the target set
temperature.
To Change Temperature Set Point:
1.
Press and hold either button for three seconds then release. The
current set point temperature will be displayed.
2.
Press the upper button to raise the set point temperature. Press the
lower button to lower the set point temperature.
3.
No further action is required.
NOTE: Turning OFF the power switch turns off the refrigeration system,
as well as the case light. Keep ON to keep case cold!
NOTE: Do not load any product until the refrigerator has reached target
temperature.
