Bourgogne
Poêle mixte
Réf. 124.13.04
English
Wood or coal stove - model 124.13.04
Technical manual
To be saved by the user for future reference.
WARNING
The appliance must be installed in compliance with Current Building Regulations.
Incorrectly installed, this appliance can be dangerous
and possibly cause serious accidents.
The manufacturer’s responsibility shall be limited to the supply of the equipment.
q
General installation instructions
The room
Ventilation :
For satisfactory operation with a natural draught,
check that sufficient air for combustion is available in
the room.
Chimney position :
For new chimney installations , select a central
position within the building, to provide a good heat
distribution around the building.
Hearth :
The hearth must be suitable for use with solid fuel
burning appliances and must comply with Current
Building Regulations. If in doubt, consult your Dealer
or local Building Inspector.
Rear wall and ceiling :
The appliance must not be positioned close to
combustible materials, wall & ceiling surfaces etc.,
Consult your Dealer or local Building Inspector if in
doubt.
Flue :
Existing flue :
- The flue must be in good condition and must provide
sufficient draught.
- The flue must be suitable for the installation of solid
fuel burning appliances and comply with Current
Building Regulations.
- The flue must be clean. It should be swept to remove
soot and dislodge tar deposits.
- The flue must be well insulated. If the flue inner wall
surfaces are cold, a good thermal draw is impossible
causing condensation problems (tar formation etc) to
occur.
- The flue must not be shared with other appliances.
- The recommended minimum flue height is 5 metres.
- If the chimney has any down draught tendency, due
to its position in relation to nearby obstacles, then an
anti-down draught cowl must be installed on the
chimney or the chimney height must be increased.
- If the decompression in the chimney is excessive, a
draught stabiliser must be installed.
Chimney to be built / Flue non-existent :
- The flue must not be supported by the stove.
- Consult a chimney specialist for advice on suitable
flue systems for solid fuel appliances.
Connection to flue :
- The stove must be installed as close as possible to
the chimney.
- The stove should be connected to the flue by a
smoke pipe, approved for installation with combustion
products (e.g. stainless steel 1 mm thick, 20g, or
vitreous enamel.).
- Pipe diameter must not be less than the appliance
spigot diameter.
- The connection can be either vertical or horizontal.
For horizontal connections, avoid right angle bends.
- The join between the connection pipe and the
stovepipe, and the flue, must be leak tight.
- The connection pipe and any draught stabiliser must
have access for cleaning. q
Notice de référence
Document n° 729-3 ~ 09/01/1996
11
