___________________________________________________________________________ NT 1965 A - 03/201919
The installer menu contains all the parameters relating to the configuration of the unit's functions (alarms, settings,
logic, specifications, etc.). Using the RIGHT and LEFT buttons to navigate, you can access the menu to configure the
installer level password. In the CLOCK menu, you can configure the parameters relating to programming management.
In the
FANS
,
HEATERS
,
RECOVERY UNIT and FILTRATION
menus, you can configure the parameters relating to device
management.
The
SAFETY
menu contains the parameters concerning alarms and the management of safety devices for the
appliances.
In the COMMUNICATION menu, you can configure the parameters relating to MODBUS RTU communication
The
OTHER PARAMETERS
menu contains other general parameters.
In the
PARAMETERS
menu, you can access the page for restoring parameters to the factory settings, or for
saving/restoring the parameters on a key or in the controller memory.
For different configurations, see 8.1 Liste des paramètres de configuration on page 27
In the INSTALLER menu, you can change the password (PSd3) by pressing on the RIGHT button.
6.7.1
SETTINGS
6.7.1.1
Restoring default parameters (PH99)
Using the
“Restore parameters”
procedure, you can restore all of the installation's parameters to the default values.
You can only activate this procedure if the machine is OFF. Enter the
Installer -> Parameters ->
menu and press ENTER.
Configure parameter
PH99= "YES" (1)
and wait until the value
“NO” (0)
is displayed again on the screen. The system
will automatically restore all the parameters.
NB:
After this operation, power the machine down, then power it up again, in order to avoid malfunctions
6.7.1.2
Saving/restoring parameters
You can save the value of all parameters of the installation in the programming key and thus enable them to be copied
into one or more compatible instruments. The save or restore operation can only be carried out if the machine is
OFF.
It is possible to save/restore the parameters on a USB key or in the controller memory.
