27
English
Operating instructions
15cm
15cm
15cm
15cm
3.3 INSERTING CAM MODULES
To insert the CAM modules in the slots, position the module as shown in the figure and press it lightly.
The module should slide along the guides freely. If it does not, check they are correctly aligned and the insertion direction. To extract the CAM
modules pull slightly to one side and the module should come out without difficulty.
3.4 MULTICOLOUR STATUS LEDS
D-MATRIX 4S EVO has four multicolour LEDs on the top (one for each input), to indicate the sat signal reception status, and one multicolour led
on the bottom showing the system status.
The following table gives a useful summary to interpret the lighted LEDs.
INPUT STATUS LED
Off:
Input off
Orange: Input active waiting to lock
Green:
Input active and locked
Red:
Input overloaded
SYSTEM STATUS LED (during initialisation)
Orange: Boot system
Red:
start applications
Green:
System started without error
SYSTEM STATUS LED (system started)
Green:
Normal
Orange: Anomaly
Flashing red: Update and/or recovery phase
4. OPERATING INSTRUCTIONS
• Wait until the D-MATRIX 4S EVO is initialized (the display shows D-MATRIX FRACARRO)
• To access the panel menu, press V, type in the user code (default code is 1234) and confirm by pressing V.
• Program as instructed below (see the paragraph 5.1. BASE PROGRAMMING FROM THE PANEL).
• Check the output signal is available by using a field meter
• Connect the distribution cable to the output connector
