FPI P36D Zero Clearance Direct Vent Gas Fireplace
47
FLUSH LOUVERS
1) Install the top louver by sliding the two
bracket clips into the brackets located un-
derneath the top of the firebox.
2) The bottom louver has a hinge that is at-
tached (2 screws per hinge) to the lip on
bottom of the unit.
3) Open the bottom louver. Pull the Burner ON/
OFF control box from inside the bottom of
the fireplace and position the slots in the
bracket over the 2 screws on the left side
of the bottom louver. Push down to lock into
place. Tighten the screws.
Screws on
louver bracket
Burner ON/
OFF control
box
attached to
bottom flush
louver.
Burner ON/OFF
control box
FLUSH TRIM
Attach the round magnets to the back of the top
trim piece and to the bottom trim piece, then
attach trim to the top and bottom of Flush door.
DOUBLE
SCREEN DOOR
1) Pull out the top louver.
2) Center the screen door and hook over the
flush door.
3) Open the screen door(s) and secure the
screen door to the flush door front with 2
clips on the bottom left and right side.
Clip locations
Clip installed on right side.
Note: Top and
bottom louvers
are different.
REGENCY OPTIONS
Summary of Contents for P36D-LP
Page 6: ...FPI P36D Zero Clearance Direct Vent Gas Fireplace 6 UNIT DIMENSIONS...
Page 46: ...FPI P36D Zero Clearance Direct Vent Gas Fireplace 46 FLUSH BAY DOOR OPTIONS...
Page 53: ...FPI P36D Zero Clearance Direct Vent Gas Fireplace 53 CAST FACEPLATE...
Page 62: ...FPI P36D Zero Clearance Direct Vent Gas Fireplace 62 REPLACEMENT PARTS LIST...
