Foxconn T99B226, Manual

Page: 21 / 37

2
）
Static IP: The gateway WAN port address should be set by the user. Contact your IT
administrator for the corresponding information.
a.
IP address: enter the IP address information provided by the superior route.
b.
Subnet mask: enter the subnet mask provided by the parent route.
c.
Gateway: enter the gateway IP address for the superior route.
After confirming that the information input is correct, click on the corresponding
application button to change the network configuration.
Figure 3.4 WAN configuration is set to Static
➢ HeMS Configuration
The Small Cell has a HeMS configuration function, this function enables the Small Cell to
communicate with Auto Configuration Server (ACS). If the configuration of this setting is
incorrect, the Small cell will lack the ability to communicate with the configuration/fault
management portion of the EPC and must rely on manual configuration of the device.
1)
Ensure that you have reserved a static IP inside of the network with IT and installed all
the necessary software for EPC.
2)
Point the Small Cell to the established IP of the EPC. Example IP:
192.168.1.222:8080/femsacs/acs
Figure 3.5 HeMS Configuration
3.3 Advanced Setting
Configure Cell Information, REM Settings and ShareRan settings - Navigate to “One Page
Setting
→
Advanced Settings”. However, if the basic Settings page has been configured
properly, this section should be auto configured by the Auto Configuration Sever (ACS).