48
CAUTION
: Switch off the machine and disconnect it from the power supply by removing the plug
from the socket before any adjustment, repair, maintenance task or when changing the blade.
Wear protective goggle when handling the saw blade.
1.
Loosen the locking lever of the blade (20) (
Fig. 43
) and turn the handle for the adjustment
of blade’s height (19) (
Fig. 44
) until the blade is at its highest position.
2.
Remove the protective cap (17) (
Fig. 45
).
3.
Remove the bench inlay (12) (
Fig. 46
).
4.
Remove the cutting knife (8) (
Fig. 47
).
5.
Use a 11 mm flat spanner (not included in the package) to keep blade’s axle (
Fig. 48
).
6.
Use a 24 mm flat spanner (not include in the package) to loosen the nut by turning it anti-
clockwise.
7.
Remove the external flange
Fig. 49
).
8.
Clean carefully blade’s flanges before re-assembling the new blade.
9.
Assemble and fix the saw blade by following the previous procedure in reverse order.
WARNING
: Pay attention to the rotational sense of the saw blade. The teeth and the arrow must
always point downwards towards the operator.
10. After ensuring that the blade and the riving knife are aligned and that the teeth and the
riving knife do not get in touch, re-assemble and lock the riving knife and lastly the
protective cap.
11. Before using the table saw again, check that all safety devices are correctly installed.
IMPORTANT
: After re-assembling the saw blade, censure that it rotates correctly and without
obstacles by rotating it by hand.
12. Connect the machine and start it for a while. Do a shear test to check that there is not any
problem.
DANGER: You must always use the protective cap for all cutting work to avoid any risk of
contact with the blade.
It raises automatically when the workpiece passes through the blade.
Connect the dust-collection device to the back output of the machine.
A suitable extraction device or an external dust collector can be connected to the machine, in the
back side of the base there is the coupling for the aspiration pipe.
Always connect the table saw to an external dust-collection device, since the dust of different
kinds of wood can be dangerous for the health of the operator.
We recommend you to always use a dust collector to remove the dust which has been produced
while using the machine. Besides, it is preferable that you clean accurately the machine to
remove all dust piles.
REPLACEMENT OF THE BLADE
DUST COLLECTION
Summary of Contents for F36-521
