33
1.
DO NOT
start the saw until it is assembled and installed according to the instructions of this
manual.
2.
ALWAYS USE
the protective cap, the riving knife and the clamping device in order to cut
the piece completely. This means cutting the piece in all its depth.
3.
ALWAYS PRESS
the workpiece firmly against the oblique guide or on the rip fence.
4.
USE
always a clamping device in order to push the piece of wood through the blade and in
particular to cut small pieces. To get further information on the clamping device, check the
sections regarding longitudinal cutting in this manual.
5.
NEVER
work freehand. Always use the oblique guide or the rip fence to position and direct
the piece you are cutting.
6.
ALWAYS KEEP A SAFE DISTANCE
from the blade axe.
KEEP
the hands away from the
blade’s track.
7.
DO NEVER
keep your hands behind or over the blade and ensure that you and your hands
are in a comfortable position.
8.
REMOVE
the rip fence during cross cutting.
9.
DO NOT USE
the rip fence for cross cutting.
10.
PUSH ALWAYS
the piece you have to cut through the saw blade or the tool.
11.
DO NOT TRY
to remove the saw blade before switching off the tool. Also if you want to
stop cutting, put the switch on the OFF position and wait for the blade to stop rotating. You
can perform tasks of any kind only if the blade is still and the machine is disconnected from
the power supply.
12.
DO NOT
remove wood piles caught between the blade and the inlet if the blade is rotating.
You can intervene after switching off the machine and having waited for the blade to stop
rotating.
13.
LEAN
on a support the ends of big workpieces which come out sideways or behind the
workbench.
14.
AVOID
workpieces hittig back in your direction by taking the following measures:
A. Always use a sharp and suitable saw blade;
B. Check the parallelism between the guide and the blade;
C. Always use the riving knife, the clamping device and the protective cap;
D. Never release the workpiece before it has been completely pushed through the saw;
E. Do not saw bent or deformed workpieces which do not have a straight side that allows a
regular advancement along the guide.
15.
NEVER USE
thinners to clean the plastic pieces of the machine. Thinners can melt or
damage the material. Only use a damp cloth for cleaning plastic workpieces.
SPECIFIC SAFETY RULES FOR CIRCULAR SAWS
Summary of Contents for F36-521
