49
MANTEINANCE
CAUTION
: Switch off the machine and disconnect it from the power supply by removing the plug
from the socket before any adjustment, repair, maintenance task or when changing the blade.
In case you find out any damage to the protection devices or irregularities while processing or
checking the machine, you must get it repaired immediately by qualified persons.
Before use check that the protection and safety devices are perfectly efficient. After carrying out
the work, make a general cleaning of the machine by removing dust and chips.
Extract periodically sawdust that can pile up inside the machine and clean the ventilation inlets
of the engine.
Be sure that the protective cap can slide freely.
Be sure that the saw blade group can smoothly lift, lower and incline from 0 to 45°.
Check the noise of the engine periodically and brushes’ consumption.
Periodically check that the supply cable is not damaged.
Periodically check the tension and conditions of the belt.
CHECK AND REPLACEMENT OF ENGINE’S BRUSHES
1.
Disconnect the machine from the socket.
2.
Turn the machine upside-down on a piece of cardboard.
3.
Remove the bottom plate by loosening the 4 screws.
4.
Loosen the cover of the engine’s brushes with a suitable screwdriver. One of the brushes is
on the opposite side of the engine.
5.
Remove the worn brushes. Each brush must be at least 6 mm long.
6.
Insert the new brushes in the in their slot. The two pins of the upper metallic side of the
brush must be positioned in the guide of the slot of the brushes.
7.
Screw the covers of the brushes.
8.
Check that the machine works correctly.
REPLACEMENT OF THE BATTERIES OF THE POINTING DEVICE
CAUTION
: Switch off the machine and disconnect it from the power supply by removing the plug
from the socket before any adjustment, repair, maintenance task or when changing the blade.
1.
Position the blade in its highest position.
2.
Remove the protective cap (17).
3.
Loosen the two screws (11) (
Fig. 50
), let the two lock pins of the cover of the slot in order
to get at the batteries of the pointing device (
Fig. 51
). Remove the two batteries.
4. Replace them with two new batteries of the same type (or equivalent). Be careful to
position them in the same direction as the old ones.
5.
Close the cover of the slot.
6.
Check and adjust the laser beam if necessary.
Summary of Contents for F36-521
