Four winns 258 VISTA, Owner'S Manual

Page: 70 / 259

Owner’s Manual Page Control Systems - Section F
F - 1 GENERAL
Control systems permit operation of the engine’s
throttle and shift mechanisms. Typically, they consist
of three major components; the control, the throttle
and shift cables.
The 258 and 278 Vista
®
stern drive models are
equipped with single engine side-mount control with
trim. See Figures F1 and F2. The left lever controls
the port engine and the right lever controls the star-
board engine. Moving the lever forward will shift the
drive into forward. Moving it aft will shift the drive into
reverse. Moving the lever further will increase engine
speed.
Figure F1: Dual Engine Binnacle Control
Figure F2: Helm Station
NOTICE
Allow the engine to warm up before engaging
the shift control. Monitor all instruments while
engine is idling during warm-up.
F - 2 CONTROL OPERATION
A. General
NOTICE
The control information included in this section
is general only. For specific operation of the
controls on your boat, refer to the control
manufacturer’s literature and engine
manufacturer’s literature included in your
owner’s packet. Ensure you completely
understand the operation of the controls before
operating your boat. Also consult your dealer
should any questions arise regarding the
operation of the control unit.
NOTICE
If your boat is equipped with a non-OEM
remote control system, ask your dealer how to
properly operate it.
NOTICE
Reduce throttle as soon as motor starts. Do
not run a cold motor any faster than necessary
to keep motor from stalling. Do not exceed
000 RPM in NEUTRAL.
B. Maneuvering of Side-Mount Control
Shifting and engine speed are controlled with the
same lever (1). See Figure F3.
N - Neutral position. Drive/Reverse gear dis-
engaged.
F - Drive/reverse gear engaged for forward
movement (ahead).
R - Drive/reverse gear engaged for backward
movement (astern).
T - Engine speed control.
Trim/Tilt Switch - Push top of switch or where
indicated to trim out and tilt up, or push bottom of
switch or where indicated to tilt down and trim in.
Control Systems