Four winns 258 VISTA, Owner'S Manual, Page: 76 / 259

Owner’s Manual Page Electrical Systems - Section H
A. Installation
1. Connect each of the red (positive) battery cables
leading from the battery selector switch to the
positive (+) terminal on each of the two batteries.
Refer to Figure H1.
Figure H1: Dual Battery Systems
NOTICE
Be sure the two red (positive) cables are in-
stalled on the positive (+) battery terminals.
2. Connect each of the black (negative) battery
cables leading to the engine block to the negative
(-) battery terminal on each of the two batteries.
When disconnecting the cables from the
battery, make sure all switches are off and
disconnect the black negative cable(s) first to
prevent spark.
H - 1 GENERAL
All electrical equipment on the Four Winns 258 & 278
Vista
®
models operates on 12 volts DC or 120 volts
(220 volts on 50 Hertz models) AC electrical power.
The 258 and 278 Vista
®
models are equipped with dual
battery systems along with dockside power (including
battery charger) as standard features. Batteries are
located in the engine compartment.
Fire or Explosion Hazard!
Electrical system parts are designed by and
manufactured to comply with the US Coast
Guard requirements to minimize risks of fire
or explosion. Never substitute automotive
parts for marine parts. Automotive parts do
not provide the necessary ignition spark
protection.
DO NOT tamper with any electrical connection,
panel or harness, or attempt installation of any
electrical equipment unless thoroughly familiar
with the systems and experienced in making
such installations.
Circuit breakers are installed on the battery switch to
protect various system components. The SHIP SYS-
TEMS breaker supplies power to all DC electrical
components except the aft bilge pump and forward
bilge pump (if applicable), stereo, ignition, and instru-
mentation. Additional breakers are located in the cabin
circuit breaker panel. The circuit breakers and/or fuses
are labeled for amperage and use.
The dash components are protected by a fuse panel.
Refer to Figure to the wiring schematics in the back of
this manual.
H - 2 SINGLE ENGINE - DUAL BATTERY
SYSTEM
A battery selector switch is installed on the dual battery
system. This allows DC power to be used from either
one or both batteries. Refer to the schematics in the
back of the manual.
Electrical Systems
258 Vista
278 Vista